top of page

ISSUES WITH MESH UNIT AND SETTING IT UP

This article is exclusively for the mesh that works with the GigaSpire Blast U6 router.

Backhaul Lights Not On

The mesh has not successfully synced.

  1. Ensure that the same room as your router.

  2. Press and hold the WPS button on the back of the device until the Wi-Fi Backhaul lights begin to blink green, then release the button.

  3. On the mesh unit, press the WPS button on the back of the device until the Wi-Fi Backhaul lights begin to blink green, then release the button.

  4. Allow 15 minutes for both devices to sync. This may power cycle the mesh a few times. Unplug and move the mesh to the desired location in your house ensuring that you have 3-4 green Wi-Fi green backhaul lights. 

Mesh Power Light is Not Green; No Other Lights are on

The mesh may be applying firmware updates. Wait 15 minutes and perform a power cycle by unplugging the mesh for 60 seconds and then plugging it back in.

For more troubleshooting, contact our tech support at support@fiberbycentralflorida.com

Setting up Your Mesh

bottom of page